control condition
英 [kənˈtrəʊl kənˈdɪʃn]
美 [kənˈtroʊl kənˈdɪʃn]
网络 控制条件; 控制状态; 控制环境
英英释义
noun
- a standard against which other conditions can be compared in a scientific experiment
- the control condition was inappropriate for the conclusions he wished to draw
双语例句
- Hand picking, hand selection, ferment under temperature control condition to extract the noble of fruit essence, aging in oak barrel.
人工采摘,人工分选,控温发酵,以完美体现葡萄品种的高贵特性,橡木桶陈酿。 - Short Service Time Cell Selection and Admission Control Condition B proposed in this thesis is one of the suggestions of RRM solution.
在单业务的假设下,本文对服务小区选择和接纳控制进行初步研究,提出最短服务时间小区选择和实时业务接纳条件,具有一定的创新性和实用性。 - Driving system of electric vehicle based on DTC is researched according to the actual control condition of the electric vehicle.
针对电动汽车实际控制条件,提出了电动汽车直接转矩控制系统的实现方案。 - Slope stabilization is chief control condition in foundation issue.
边坡稳定是土工问题的首要控制条件。 - This allows the control condition to be comprised solely of local variables and therefore run much faster.
这使得控制条件只有局部变量参与运算,所以速度更快。 - General Transient Equivalent Circuit and Correction of Field Acceleration Control Condition for Induction Motor
感应电动机的通用等值电路和磁场加速控制条件的修正 - The generation and composition of coking sewage are analyzed. The application of A1-A2-O technique in the coking sewage disposal and the key technological parameters control in each stage is introduced, and the optimized control condition of the integral technological parameter is roughly analyzed.
分析了焦化污水的产生和组成,介绍了A1-A2-O工艺在焦化厂污水处理中的应用及各阶段重要工艺参数的控制,并对整体工艺参数的最佳控制条件进行了浅析。 - The simulation results show, this system not only accord with characteristic demand from target tracking, but can effectively depress the interference with system load and better meet the control condition of jointed robots.
仿真结果表明,该系统既可满足对目标跟踪的品质要求,又可对系统的负载干扰进行有效的抑制,能够较好地满足并联机器人的控制要求。 - Theory and Application of the Vacuity Measurement of the Vacuum Interrupter without the Magnetic Control Condition
非磁控条件下真空开关真空度测量的原理及应用 - The actual control condition at the root of the notch is more problematic.
在缺口根部的实际控制条件是更难捉摸的。